Miele DA 3060 Wartungshandbuch

Operating and installation instructionsCooker hoodDA 3060To avoid the risk of accidentsor damage to this appliance,it is essential to read theseinstru

Guide to the appliance10

a Exhaust socket ø 150 mmb Control panelc Grease filterd Pull-out deflector platee Hob lightingf Charcoal filter(extra accessory available to orderfor

A range of Miele branded cleaning andconditioning agents are available toorder through your Miele Dealer /Chartered Agent, the Miele Spare PartsDepart

ControlsThe controls may sufferdiscolouration or damage if soiling isleft on them for too long. Removesoiling straight away.Observe the General notes

Cleaning the grease filters by hand^Clean the filters with a soft nylonbrush in a mild solution of hot waterand a small amount of washing-upliquid.Do

Fitting and replacing thecharcoal filterIf the cooker hood is connected forrecirculation, a charcoal filter (optionalaccessory) must be inserted in ad

Changing a halogen lamp^Pull out the deflector plate, andremove the grease filter as describedearlier.^Switch off the fan and the lighting.,Exercise c

1) The front section of the wall housingunit must be fitted with a shelf to thedepth of the partition wall.2) The partition wall in the wall unit must

Installation accessoriesInstallation18

a 1 exhaust connectionfor exhaust ducting C 150 mm.b 1 reducing collarfor exhaust ducting C125 mm.c 1 non-return flapfor fitting into the exhaust sock

Caring for the environment. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3Warning and Safety instructions . . . .

Installation20

Positioning the appliance inthe wall housing unitTo position the appliance correctly,cut the spacer strip to required depthT, and then attach it to th

^Screw the brackets onto the right andleft inside walls of the housing unit asshown. The back edge of thebrackets should align with the verticalline d

^ Lift the appliance up into the housingfrom below, and engage in thebrackets.Note for dismantling the cooker hood:Undoing the screws on the left andr

^Secure the front of the appliance tothe floor of the housing unit frombelow using 4 screws.To avoid damaging the deflector platewhen it is pulled out

Attaching the lightshield^Attach the lightshield (if using).A DML 300 installation kit, available asan optional accessory, is required forthis. This i

Fitting the grease filter^Remove the protective strip aroundthe edge of the grease filter.Fit the grease filter.^To do this, pull the deflector plateo

Set up for extraction mode^If the on-site ventilation system doesnot have a non-return flap, then thenon-return flap supplied with theappliance must b

Set up for recirculation modeIf site conditions are not suitable for thecooker hood to be used with airextraction, the appliance must be setup for rec

Important: To avoid the danger oftoxic fumes, please observe theWarning and Safety instructions.This is especially crucial when usingthe cooker hood a

Disposal of the packing materialThe transport and protective packinghas been selected from materials whichare environmentally friendly fordisposal, an

Condensate trap(optional accessory)In addition to insulating the exhaustducting, we recommend that a suitablecondensate trap is also installed tocolle

Silencer(optional accessory)To achieve even further reductions innoise levels, a special silencer can befitted in the ducting system...with air extra

All electrical work should beundertaken by a suitably qualifiedand competent person in strictaccordance with current nationaland local safety regulati

In the event of a fault which you cannotcorrect yourself, or if the appliance isunder guarantee, please contact:–Your Miele Dealer / Chartered Agentor

Connected load...210WFan motor ...110WHob lighting ...2x50WVoltage ...230VFrequency...

35

Alteration rights reserved / 1111M.-Nr. 07 773 930 / 02

This appliance complies with allrelevant local and national safetyrequirements. Inappropriate usecan, however, lead to personal injuryand damage to pr

Technical safety~Before installation, check the cookerhood for visible signs of damage.Under no circumstances should youuse a damaged appliance. A dam

~Do not connect the appliance to themains electricity supply by amulti-socket unit or an extension lead.These do not guarantee the requiredsafety of t

In order to ensure safe operation, andto prevent gases given off by theheating appliances from being drawnback into the room when the cookerhood and t

~The filters should be regularlycleaned or changed as appropriate.Saturated filters are a fire hazard. See"Cleaning and care".~The cooker ho

The cooker hood works with. . . air extraction:The air is drawn in, cleaned by thegrease filter and then directed outside.If the on-site ventilation s