Miele KM411 Bedienungsanleitung

Installation InstructionsCeramic hobsKM 400 / KM 412 / KM 418Ceramic contact grill KM 408-1Open grill KM 410 / KM 411Deep fat fryer KM 402 / KM 403It

KM 418a Spring clampsb Building in heightc Frontd Building in height including electrical connection boxAppliance dimensions10

Dimensions 7 mm and 11 mm are thespace taken up by the frame of theappliance on the worktop.^ Make a cut-out for the hob in theworktop, paying attenti

Fitting the spacer bars andspring clampsa Spring clampsb Spacer barsInstallation of several appliancesThe illustration above shows anexample of a work

Fixing the spacer bars^ Position the spacer bars b in thepositions shown in "Fitting the spacerbars and spring clamps" so they areflush with

Building in the appliance^Guide the hob electric cable down through the cut-out and connect theappliance to the electricity supply.^ Position the hob.

ImportantUnder no circumstances shouldsealant find its way between theframe of the top part of the hob andthe worktop.This could cause difficulties if

All electrical work should be carriedout by a suitably qualified andcompetent person in strictaccordance with national and localsafety regulations.For

17

18

19

Warning and Safety instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3Building in . . . . . . . . . . . . . . . .

Alteration rights reserved / 3905M.-Nr. 05 021 213 / 02en - AUS

Building inFit wall units and the cooker hoodbefore fitting the appliance, to avoiddamaging it.The veneer or laminate coatings ofworktops (or adjacent

After installation ensure that theconnection cable is withouthindrance and that there is nomechanical obstruction which coulddamage it, such as a draw

Safety distance between the KM 410 /KM 411 and a cooker hood above itFor safety reasons, the minimumsafety distance between the KM 410KM 411 Open gril

KM 400a Spring clampsAppliance dimensions6

KM 408-1 / KM 412a Spring clampsb Protective shelf (KM 408-1 only)A protective shelf and a front panelmust be fitted underneath KM 408-1to ensure that

KM 402 / KM 403a Spring clampsb Drain tapAppliance dimensions8

KM 410 / KM 411a Spring clampsb Drain tapAppliance dimensions9