Miele KM 5753 Bedienungsanleitung PDF herunterladen (Seite 49)

Safety instructions for

installation

Fit wall units and extractor hood

before fitting the hob to avoid

damaging the surface.

The veneer or laminate coatings of

worktops (or adjacent kitchen

units) must be treated with 100 °C

heat-resistant adhesive which will not

dissolve or distort.

Any backmoulds must be of

heat-resistant material.

This equipment may only be used

in mobile installations such as

ships, caravans, aircraft etc. if a risk

assessment has been carried out by a

suitably qualified engineer.

The hob may not be built in over a

fridge, fridge freezer, freezer,

dishwasher, washing machine or

tumble dryer.

These hobs must not be installed

above ovens or cookers unless

these have a built-in cooling down fan.

After installing the hob, ensure that

the connection cable cannot come

into contact with the underside of the

appliance. Make sure that there is no

mechanical obstruction, such as a

drawer, which could damage it.

If a protective shelf is installed

under the built-in hob, there must

be a minimum distance of 150 mm

between it and the top of the worktop to

allow for ventilation to the appliance.

Observe carefully the safety

distances given on the following

pages.

Do not use any sealant except

where expressly instructed to do

so. The seal underneath the appliance

provides a sufficient seal for the

worktop (see "Sealant").

All dimensions in this instruction booklet

are given in mm.

Installation

49

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 71 72

Kommentare zu diesen Handbüchern

Keine Kommentare