Miele CS 1028 Bedienungsanleitung PDF herunterladen (Seite 21)

Switching on, adjusting the

flame and switching off

The control knob is used to ignite the

burner and regulate the strength of the

flame.

ß The gas supply is turned off

* Ignition setting

& Stongest flame

/ Weak flame

The burner can only be switched on

by pressing in the control and

turning it anti-clockwise. It is

switched off by turning the control

clockwise.

The following will cause damage to

the appliance:

- Switching on the burner without

pressing the control down,

- Switching the burner on by

turning the control clockwise,

- Switching the burner off by

turning the control

anti-clockwise.

The manufacturer will not accept

liability for any damaging resulting

from incorrect operation.

Switching on

^

The control for the burner must be

pressed in and turned anti-clockwise

to the ignition position a to switch

on.

^

When the flame ignites, keep the

control pressed in for 8-10 seconds,

and then let it go.

^

If the flame goes out turn the control

to "ß" and wait for at least 1 minute

before trying to ignite it again. If

necessary keep the control pressed

in for longer.

^ If the burner does not ignite after a

second attempt turn the control back

to "ß" and go to the "Problem solving

guide" for advice.

In the event of a power cut

If there is an interruption to the

electricity supply the gas can be

ignited with a match:

^

Press in the control and turn it

anti-clockwise to the ignition position.

^

Hold the control pressed in and light

the gas at the burner with a match.

^

Keep the control pressed in for a

further 8-10 seconds and then

release it.

Operation

21

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 55 56

Kommentare zu diesen Handbüchern

Keine Kommentare