Miele KM 2012 Bedienungsanleitung Seite 1

Operating and installation instructionsGas cooktopsTo avoid the risk of accidents or damage to the appliance it is essentialto read these instructions

Technical safety~Before installation, check theappliance for visible signs of damage.Do not install and use a damagedappliance. A damaged appliance is

~The gas cooktop must bedisconnected from the gas supply andmains electricity before repairs andmaintenance work is carried out. It isonly completely

Correct use~The appliance gets hot when in useand remains hot for quite a while afterbeing switched off. Do not touch itwhilst it could still be hot.~

~Unless the pan manufacturer statesthat you can do so, do not use panswith very thin bases on this cooktop,and never heat up empty pans as theycould g

Disposal of the packingmaterialThe transport and protective packinghas been selected from materials whichare environmentally friendly for disposaland

Please adhere the extra data plate for the appliance suppliedwith this documentation in the space provided in the "Aftersales service" secti

The control is used to ignite the burner and to regulate thestrength of the flame.ßThe gas supply is turned off& Strong flame/ Weak flameThe burne

In the event of a power cutIf there is an interruption to the electricity supply the gas canbe ignited with a match.^Press in the relevant control and

Burner Min. pan base diameter in cmSmall burner 10Medium burner 12Large burner 14Wok burner 14Max. diameter at top of pan in cmSmall burner 22Medium b

–Always place the pan on the pan support supplied with thecooktop. Do not place a pan directly on top of the burner.–Remember when purchasing new pans

WO This appliance can be used in countries other than those specified onthe appliance. It is, however, set up for connection to the gas and electricit

This appliance is fitted with a thermoelectric ignition safetydevice which cuts off the supply of gas to a burner if theflame goes out, for example if

,Do not use a steam cleaning appliance to clean thisappliance. The steam could reach the electricalcomponents and cause a short circuit.–The appliance

Cleaning NotesStainless steelsurfacesClean stainless steel surfaces using an OriginalMiele all purpose microfibre cloth or with asolution of warm wate

To assemble the small, medium and large burners^ Place the burner head c onto the burner base d so theignition safety device e, the ignitor f and the

To assemble the wok burner^ Place burner head c onto burner base d so that theignition safety device e and the ignitor f extend throughtheir respectiv

,Repairs to the gas and electrical components of thisappliance must only be carried out by a suitably qualifiedand competent person to ensure safety.

... the ignitor on the burner does not spark.Check whether–the mains fuse has blown. If it has, contact a qualifiedelectrician or Miele.–food deposits

Miele offers a comprehensive range of useful accessories aswell as cleaning and conditioning products for your Mieleappliances.These can be ordered on

Fit the wall units and rangehoodbefore fitting the cooktop to avoiddamaging the surface.~This appliance must not beconnected to a gas flue. It must be

Safety clearance above the cooktopA minimum safety clearance must bemaintained between the cooktop andthe rangehood above it. See therangehood manufac

Guide to the appliance ...5Cooktop ...5Burners ...

Side / rear clearances to the cooktopIdeally the cooktop should be installedwith plenty of space on either side.There may be a wall at the rear and at

Before installing the appliance, checkthat the location provides the requiredclearances from combustible materialand, if necessary, provide protection

KM 2012a Frontb Building-in depthc Gas connection R 1/2" ISO 7-1d Mains connection box with mains connection cable, L = 2,000 mmAppliance and bui

Preparing the worktop^Make the worktop cut-out followingthe dimensions applicable.Remember to maintain a minimumsafety clearance from the back wall,as

SealantDo not use any sealant unlessexpressly instructed to do so. Thesealing strip under the edge of the toppart of the cooktop provides a sufficient

All electrical work should be carriedout by a suitably qualified andcompetent person in strictaccordance with the wiring rulesand national and local s

Connection to the gas supply, orconversion from one type of gas toanother should only be undertakenby an approved gas fitter, who isresponsible for co

The gas connection must be inaccordance with national and localregulations.The relevant building regulationsmust also be observed.Natural gas / liquid

Nominal ratings for all gas types with the burner full onGas type KM 2012MJ/hSmall burner NGULPG4.13.6Medium burner NGULPG7.06.5Large burner NGULPG--W

,Connection to the gas supply, or conversion from one type of gas toanother, should only be undertaken by an approved and registered gasinstaller in s

Gas connection ...36Burner ratings ...38Conversion to a

Changing the jetsDisconnect the gas cooktop fromthe electricity supply by switchingoff at the socket or by disconnectingthe mains fuse.To change the m

To change the small jet(for all burners)The top of the appliance has to beremoved before the small jets can bechanged.^Loosen the fixing screws on the

After changing the jets^Reassemble the burner parts in thereverse order,^Check all gas fittings for leaks byoperating the burner without the topsectio

In the event of any faults which you cannot remedy yourself, please contact:–Miele (see back of manual for contact details).When contacting Miele, ple

44

45

46

47

M.-Nr. 07 143 630 / 03en - AU, NZKM 2012

Cooktopa Wok burnerb Small burnercd Medium burnersControls:e Front rightf Rear rightg Rear lefth Front leftGuide to the appliance5

BurnersWok burner Small, medium and large burnersa Burner ringb Burner capc Burner headd Burner basee Ignition safety devicef IgnitorGuide to the appl

Accessories suppliedThe accessories supplied with your appliance as well as arange of optional ones are available to order from Miele (see"Option

This appliance complies with allrelevant local and national safetyrequirements. Inappropriate usecan, however, lead to personalinjury and damage to pr

Safety with children~This appliance is only intended foruse by adults who have read theseinstructions. This appliance is not a toy!To avoid the risk o