Miele KM6381 Bedienungsanleitung PDF herunterladen (Seite 52)

Installation

52

Preparing the worktop

 Mak

e the worktop cut-out as shown

in the building-in diagram. Observe

the safety distances (see "Safety dis‐

tances").

 Seal the cu

t surfaces with a suitable

sealant to avoid swelling caused by

moisture. The sealant must be heat-

resistant.

Make sure that the sealant does not

co

me into contact with the top of the

worktop.

The seal underneath the hob will hold

it secur

ely in the cut-out. Any gap be‐

tween the frame and worktop will re‐

duce with time.

Connecting the mains connec‐

tion

cable to the appliance

The mains connection cable must

on

ly be connected by a suitably

qualified and competent person.

 F

ollow the instructions in the wiring

diagram (see "Electrical connection -

Wiring diagram").

Installing the hob

 F

eed the mains connection cable

down through the cut-out.

 Pl

ace the hob centrally in the cut-out.

When doing this, make sure that the

seal under the hob sits flush with the

worktop on all sides. This is impor‐

tant to ensure an effective seal all

round.

Do not use sealant (e.g. silicone).

If the seal does not meet the worktop

correctly on the corners, the corner ra‐

dius (≤ R4) can be carefully scribed to

suit.

 Co

nnect the hob to the mains.

 Check that the hob works.

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 58 59 60

Kommentare zu diesen Handbüchern

Keine Kommentare