Miele KM6389 Handbuch PDF herunterladen (Seite 57)

Hob with frame or bevelled edge

57

Installation

Preparing the worktop

 Make the worktop cut-out as shown

in the building-in diagram. Observe

the safety distances (see "Safety dis‐

tances").

 Seal the cut surfaces with a suitable

sealant to avoid swelling caused by

moisture. The sealant must be heat-

resistant.

Make sure that the sealant does not

come into contact with the top of the

worktop.

The seal underneath the hob will hold

it securely in the cut-out. Any gap be‐

tween the frame and worktop will re‐

duce with time.

Connecting the mains connection

cable to the appliance

The mains connection cable must

only be connected by a suitably

qualified and competent person.

 Follow the instructions in the wiring

diagram (see "Electrical connection -

Wiring diagram").

Installing the hob

 Feed the mains connection cable

down through the cut-out.

 Place the hob centrally in the cut-out.

When doing this, make sure that the

seal under the hob sits flush with the

worktop on all sides. This is impor‐

tant to ensure an effective seal all

round.

Do not use sealant (e.g. silicone).

If the seal does not meet the worktop

correctly on the corners, the corner ra‐

dius (≤ R4) can be carefully scribed to

suit.

 Connect the hob to the mains.

 Check that the hob works.

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 66 67

Kommentare zu diesen Handbüchern

Keine Kommentare