Miele GAS KM 81-2 Betriebsanleitung PDF herunterladen (Seite 18)

(CDN)(USA) Conversion to alternative types of gas

Changing the main jet, (does not

apply to conversion to Natural Gas).

Using a 10 and 13 mm wrench, loosen

the main jets from their holders. Use

a 13 mm wrench to counterhold.

Screw in the new main jet, once again

using the wrench to counterhold.

Changing the small jets

Natural gas

Liquid gas

© Small jet with smaller orifice (e. g. for

propane gas: 0.25)

© Small jet with larger orifice (e. g. for

propane gas: 0.54)

• Using a small screwdriver, unscrew

both small jets in the gas fitting.

• Pull the jets out with a pair of pliers,

install the correct jets and secure.

Tighten to the bottom.

Do not use this screw "to adjust" the

small flame.

Save orifices removed from the

appliance for future use.

34

(CDN)(USA) Conversion to alternative types of gas

Replacing the small jet for the lowest

flame setting

Checking the first intake of air

Remove screw © from fitting ®

using an 8 mm wrench and a 12 mm

wrench to counterhold.

Then remove the screw fitting ®

from © using a 12 mm wrench and a

second 12 mm wrench to counter-

hold.

Replace the restrictor © contained

in section © with the correct restric-

tor from the table of jets (page 32).

Turn the air sleeve © to adjust the

two air vents © to the opening

illustrated (2 mm/1/16").

Assemble removed parts in reverse

order and check for leaks by opera-

ting the wok burner without the cook-

top cover in place (ignite the flame

using a match).

CO

Fastening screw

©Air sleeve

• Gap X must be 13 mm /1/2" for both

natural and liquid gas.

If this is not the case, loosen the secur-

ing screw, re-position the air jet and

then tighten the securing screw.

• Re-assemble the cooktop in the

reverse order.

35

1 2 ... 13 14 15 16 17 18 19 20 21

Kommentare zu diesen Handbüchern

Keine Kommentare