Miele GAS KM 81-2 Betriebsanleitung PDF herunterladen (Seite 19)

(CDN) (USA) Conversion to

• Screw the three screws into the

burner base using a suitable philip-

eshead screwdriver.

• Put the large burner cap base, the

burner

ring,

the large burner cap

and the wok/pan support in place.

Check that the tab of the large bur-

ner cap is correctly positioned in the

notch of the base and that the lug of

the base is correctly positioned in

the notch of the housing.

alternative types of gas

After conversion

• After converting the gas cooktop to

an alternative type of gas, place the

label supplied with the jet kit on the

data plate over the type of gas being

used.

• Check that there are no leaks.

• Check that the burner is correctly

assembled.

• Turn on the gas supply.

• Turn on the electrical supply.

• Light the burner:

When set at "low", or when the control

knob is quickly turned from

"high"

to

"low" the flame should not go out.

When set at "high", the inner cone of

the gas flame should be clearly

visible.

36

(AUS)(^NZ) Conversion to alternative types of gas

The appliance is set up for natural gas

(NG).

When converting to alternative types of

gas,

the components as listed below

have to be changed:

gas type

New

Zealand

Australia

NG

LPG

Propane

LPG

burner

small

large

small

large

small

large

jet

in

mm

N°34

2.0

N°7

1.12

N°7

1.12

adj.

screw of

control

0.40

0.88 alt.

0.90

0.23

0.52

0.23

0.52

regulator

N°1

N°2

N°2

label

for

gas type

NG

LPG

LPG

Remarks

• Changes for LPG Propane:

jets,

adjusting screws, regulator,

pane label.

• Changes for LPG:

jets,

adjusting screws, regulator,

LPG label.

Pro-

Conversion

1 Turn off the gas mains (if this ap-

ii pliance has already been installed)

i and turn off the mains electrical sup-

I

ply-

• Remove the wok/pan support, the

large burner cap, the burner ring

and the large burner cap base.

• With a cross-slotted screwdriver,

loosen the three screws.

• Pull the controls for the gas burner

up and off.

• Carefully raise the cooktop cover

slightly at the rear and pull forward.

Then carefully lift upwards and for-

wards. Ensure that the earth lead

which connects the cooktop and the

control panel is not damaged.

37

1 2 ... 14 15 16 17 18 19 20 21

Kommentare zu diesen Handbüchern

Keine Kommentare