
,
Repairs to the gas and electrical
components of this appliance must
only be carried out by a suitably
qualified and competent person to
ensure safety (Corgi registered in
the UK). Repairs and other work by
unqualified persons could be
dangerous. The manufacturer
cannot be held liable for
unauthorised work.
What to do if ...
... the burner does not ignite when
the hob is being used for the first
time or after a long period of not
being used.
There could be air lock in the gas pipe.
You may need to make several
attempts before the burner ignites
successfully.
... the burner does not ignite after
several attempts.
Turn all the controls clockwise to the "ß"
position and disconnect the appliance
from the electricity supply for a few
seconds. If the problem persists,
check whether
–
the burner is assembled correctly.
–
the gas supply tap is turned on.
–
the burner is dry and clean.
–
the flame slits are dry and
unblocked.
... there is a power cut while the hob
is operating.
Turn all the controls clockwise to the "ß"
position. You can then operate the
appliance as normal when power is
restored.
... the gas flame goes out after being
lit.
The flames need to touch the ignition
safety device so that it heats up
sufficiently.
If the flames do not touch the ignition
safety device, check that
– the burner components are
assembled correctly.
– there is no soiling on the ignition
safety device. If there is, remove it
carefully (see "Cleaning and care").
... the gas flame suddenly looks
different.
Check whether the burner is assembled
correctly.
... the gas flame goes out during
operation.
–
Check whether the burner
components are assembled
correctly.
–
There has been a power cut.
Turn all the controls clockwise to the
"ß" position. You can then operate
the appliance as normal when power
is restored.
Problem solving guide
27
Kommentare zu diesen Handbüchern