Miele KM 360 G Spezifikationen PDF herunterladen (Seite 49)

Page 49 of 100

To care for your Acri-Tec vanity top with integral sink, please read the “Zen Sink Collection

Care & Cleaning Guide” included in your Welcome Package. Again, failure to follow maintenance

instructions may void your warranty.

Here are some additional tips:

Cutting Board

Use a cutting board to protect your counters when you cut or chop. Protect the counter from heat

and from extremely hot pans. If you cannot put your hand on it, do not put it on the counter.

Caulking

The caulking between the countertop and the wall, along the joint at the backsplash and around

the sink may shrink, leaving a slight gap. Maintaining a good seal in these locations is important to

keep moisture from reaching the wood under the laminates and to prevent warping.

Mats

Rubber drain mats can trap moisture beneath them, causing the laminated plastic to warp and

blister. Dry the surface as needed.

Natural Stone Cleaning, as per the iMAC literature included in your Welcome Package

Keeping your natural stone clean is critical to maintaining the original appearance of your

countertop. “Don’t just pick up any cleaner from your local grocery store and use to clean your

stone and grout. You would be surprised how many cleaners contain at least trace amounts of

acid that can cause quick or eventual damage to fine stone and grout. Most stone and ceramic

tile outlets carry cleaners that are specially designed to properly care for these fine surfaces.”

A stone cleaner may be purchased through the iMAC store, at the address noted below.

11488 Eburne Way

Richmond, B.C.

V6V 3E1

604-324-8288

Natural Stone Sealing, Where Applicable

Please refer to the iMAC literature, included in your Welcome Package, to determine

whether or not your countertop requires sealant. If you require additional information,

please contact iMAC directly at 604-324-8288.

Keeping your natural stone sealed is also critical to maintaining your countertop’s original

appearance. Material should be re-sealed until it no longer accepts additional sealant. Coats of

sealant are usually applied 24 hours apart, so that the sealant may soak in and harden. This

process of re-sealing will help eliminate stains from occurring. Where applicable, countertops are

factory sealed; however, they will require frequent re-sealing throughout their life span. Sealing

should be re-applied once a year for granite products, and more often for marble and limestone

products. Please refer to the iMAC literature for information regarding sealants. Sealants may

also be purchased through the iMAC store, at the location indicated above.

Initial Orientation and Warranty Guidelines

During your initial orientation, we confirm that all countertops are in acceptable condition. Please

remember that stone countertops are a natural product, and will have variations in grain and

texture. Stone surfaces may even have fissures and/or tiny pinholes. Grain variations, fissures

and tiny pinholes are all acceptable conditions, as they occur naturally in the formation of stone.

We will repair the following surface damage noted during the initial orientation:

• Chips; and

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 102 103

Kommentare zu diesen Handbüchern

Keine Kommentare

Miele KM 360 G Spezifikationen Seite 49

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Kochfelder Miele KM 360 G