Miele KM 360 G Spezifikationen PDF herunterladen (Seite 58)

Page 58 of 100

The operation of a heat pump is different than that of a conventional gas fired furnace. As a

result, you will notice differences in how the temperature is maintained. The size of the unit is

based on a “heat loss” calculation, determined by the mechanical engineer. For example, unit

size is based on your individual home’s square foot size, amount of glazing and exposure (north

or south) etc. Although it is designed to maintain temperatures under normal conditions (doors

and windows closed), you should note that under extreme weather conditions the unit may not be

able to maintain a certain set point temperature. THIS IS NORMAL FOR THIS TYPE OF

SYSTEM, AND DOES NOT MEAN YOUR UNIT IS NOT WORKING CORRECTLY.

In simplified terms, your unit operates as follows. In winter, when you require heat, it extracts heat

from the closed loop geothermal system water that is piped throughout the building. It then injects

that heat, by way of a fan coil, into your unit. In summer, the reverse happens. It extracts the

heat the unit absorbs from the return air, and injects that heat into the water to be piped away

from your unit. This type of system requires more time than a conventional gas fired furnace to

increase or decrease temperature, and will function better if you leave the thermostat set at a

certain temperature. If you set the temperature significantly lower at night, it may take a bit longer

to regain the temperature in the morning. THIS IS NORMAL.

It is also important to know that your unit contains both a compressor and a fan. YOUR UNIT

WILL MAKE A CERTAIN AMOUNT OF NOISE UNDER NORMAL OPERATION. SILENT

OPERATION IS NOT REALISTIC. Please expect a level of noise similar to the noise you would

expect from a conventional furnace.

FOR MORE INFORMATION, PLEASE REVIEW BOTH THE “GEOTHERMAL HEAT PUMP”

AND THE “COOLING AND HEATING REFRIGERATION CYCLES” LITERATURE THAT WAS

INCLUDED IN YOUR WELCOME PACKAGE.

The electric panel provides shutoff breaker(s) for (among other things) the geothermal heating

and cooling system. The electric panel is normally located in either the 2

bedroom, the

masterbedroom or the storage room, behind the applicable room door. Please take the time to

note its location.

Hot Tub

If applicable, please advance to the “Outdoor Kitchen and Hot Tub” section.

Lighting

Initial Orientation and Warranty Guidelines

During the initial orientation, we will confirm that all light fixtures are in acceptable condition. For

warranty information, please refer to the “Design Lighting Warranty” letter that was included in

your Welcome Package.

Mirrors

Homeowner Use and Maintenance Guidelines

For care and maintenance instructions, please refer to the “Glass World Maintenance Guide” that

was included in your Welcome Package.

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 102 103

Keine Kommentare

Miele KM 360 G Spezifikationen Seite 58